glassbuggy |
Sun Jun 12, 2016 6:42 pm |
|
Not sure this is the place to post this but its good as any. I have a 28 Pict 1 that has a clogged accelerator jet. I know which drilling it is in. If I drill out the plug to clean it - what do I use as a plug?
|
|
ONEBADBUG |
Sun Jun 12, 2016 8:35 pm |
|
Don't drill out that plug. Remove the brass pin just above it and get the check ball out of there. Then clean from both ends. |
|
glassbuggy |
Mon Jun 13, 2016 2:57 am |
|
any tips on pulling it out? |
|
ONEBADBUG |
Mon Jun 13, 2016 9:01 am |
|
Just grab it with vice grips,wiggle and pull. Or, pry the vice grips off with 2 screwdrivers. |
|
glassbuggy |
Tue Jun 14, 2016 5:02 am |
|
That did the trick my friend ! port is now clear!
|
|
Powered by phpBB © 2001, 2005 phpBB Group
|